Dover HEIL Command-SST - Operation Modes (Continued)

Issued June 2020
Operation
Copyright 2020, Heil Environmental
Printed in U.S.A.
69
OPERATION MODES (CONTINUED)
WARNING
Moving equipment can be dangerous. Serious injury or
death may occur if a person is in the wrong area or is not
attentive to the operations. Clear the area of all
unnecessary people before you operate the controls.
F. Service Mode
1. Description: In the event of a Cylinder or Packer
Sensor failure on route, allows Qualified Service
Personnel to recover to a stowed lift position.
Maintenance Mode can also be used to move the
functions while servicing a failed Cylinder Sensor.
2. Interlocks: Some (lift cannot hit body or ground)
3. How to Activate/Deactivate: Display (defaults to
Normal Mode with Key Switch)
G.Calibration Mode
Follow the InSight Diagnostic Display instructions to
calibrate the unit . Contact Heil Technical Service at
866-310-4345 for more information.
1. Description: Allows Qualified Service to calibrate the
unit after a cylinder replacement
2. Interlocks: Some (lift cannot hit body or ground)
3. How to Activate/Deactivate: Display (defaults to
Normal Mode with Key Switch)
124