Instructions for use Babyleo TN500 SW 1.0n 185
Service
12.4 Replacing the filter cloth for patient air in the sensor
wall
The filter cloth for patient air is located in the rear of the sensor wall.
WARNING
Risk due to soiled or expired filter cloth
If the filter cloth is soiled or the life span has elapsed, the patient may be put at risk.
► Replace a soiled or worn out filter cloth.
Procedure:
1 Press the flap lock (1) down.
Fig. 87 Filter cloth for patient air in the sensor wall
2 Remove and dispose of the filter cloth.
3 Insert a new filter cloth.
4 Close the flap and check that it is securely locked.
12.5 Repair
Dräger recommends that all repairs are performed by DrägerService and that only
authentic Dräger spare parts are used.
12.6 Activating applications
An activation code is linked with the serial number of the respective device and
cannot be transferred. The activation codes can either be loaded from a USB mass
storage device or entered manually.
1 Touch the System setup... button in the main menu bar.
2 In the System setup dialog window, open the System>Service dialog page.
3 Enter the password and confirm.
4 Touch the Service menu button and confirm.
✓ The Service dialog window is displayed.
30704
To Next Page
Loading...
