Instructions for use Babyleo TN500 SW 1.0n 91
Operation
6.10 Manual mode
This chapter describes manual mode.
6.10.1 Overview of manual mode
In this mode the radiant warmer power can be set manually. To protect the patient
from overheating, time limits are set for the supply of heat above a certain power. If
the user sets the radiant warmer power above 30 %, a timer starts and the following
alarms are displayed after predefined time intervals:
– After 14 minutes the Check patient's condition alarm is displayed.
– After 15 minutes, the radiant warmer is switched off and the Warmer off, check
patient's condition alarm is displayed.
Fig. 48 Radiant warmer operation with manual mode activated
27253
No. Designation Description
1 Timer Starts with radiant warmer power settings
above 30 %. Limits the supply of heat to
15 minutes.
2 Manual mode Selects manual mode.
3 Warmer Used for setting the radiant warmer power.
To Next Page
Loading...
