Instructions for use Babyleo TN500 SW 1.0n 43
Product description
3.3.1.6 Data exchange and ports
Serial port
A serial port (COM port) is provided for data communication with the Dräger
MEDIBUS.X data protocol.
USB port
The USB port enables the following actions to be carried out once a USB mass
storage device (e.g., USB flash drive from Dräger) has been connected:
– Saving and loading device configurations
– Saving and loading patient configurations
Service port
Specialized service personnel can connect the device to a DrägerService computer.
The following are used:
– Device status queries
– Support of software installation
3.3.2 Frequently used functions
Operation
Operating the hand ports and access panels Page 53
Opening and closing the hood Page 52
Adjusting the device height Page 48
Adjusting the mattress tray Page 49
Opening and closing the drawer Page 27
Alarms
Setting alarm limits for modes and therapy controls Page 63
Suppressing the acoustic alarm signal Page 127
Dismissing the alarm message Page 130
Switching between therapy modes
Incubator operation Air temperature mode Page 85
Skin temperature mode Page 77
Radiant warmer operation Manual mode Page 91
Skin temperature mode Page 77
Setting therapy parameters
Air temperature Page 87
Skin temperature Page 82
Radiant warmer power Page 92
Mattress core temperature Page 103
Humidity Page 95
Oxygen in the patient compartment Page 97
Monitoring therapy parameters
Air temperature Page 85
To Next Page
Loading...
