54 Instructions for use Babyleo TN500 SW 1.0n
Operating concept
4.5.3 Pulling out the bed support
The bed support can be pulled out of the device on both sides, e.g., to remove the
patient for kangarooing. If the mattress tray is tilted or raised, leave sufficient space
above the patient.
Procedure:
1 Lower the mattress tray and position it horizontally.
2 Open one of the two side access panels.
3 Open the X-ray flap.
4 Pull out the bed support on one side of the device using the recessed grips (1).
Fig. 27 Bed support with recessed grips
30843
To Next Page
Loading...
