to display the time of the current lap, updating the
number of laps. When the 60th lap is reached, the
message “Full” is displayed and it is not possible to
record new times: in this case, delete the saved laps
in order to record new ones.
Use the “Lap” function in the - Vehicle”
menu to:
●
activate or deactivate the function;
●
view the recorded lap data;
●
delete recorded data.
The instrument panel stops recording the lap by
the stopwatch in the following cases:
●
If bike speed is equal to 0 5 seconds from
first lap
●
If bike speed drops below 5 km/h (3 mph) for
more than 5 seconds during lap recording.
●
If the engine is turned
The following data is recorded for each lap:
●
Time
●
Maximum reached speed
●
Maximum reached RPM
Note
The stopwatch can be only when the
motorcycle speed is higher than 5 km/h (3 mph).
Note
If during lap recording the flash (6) is
pressed to the stopwatch, any
presses occurred within 5 seconds will not be
considered by the instrument panel.
press the
to return to the
previous menu level or long press the
to
close the function menu.
154
To Next Page
Loading...
