No material feed after corner incision
Material feed/ Stacker position
After the corner incision the
feed clamps transport the material to the set
position.
Entry: 001 - 100 [mm]
Hint:
The smaller the entry, the further the carriage
moves to the rear.
1 = rear position
100 = cutting position
Carriage return w ith material f eed
After the corner incision the feed clamps
automatically transport the material back to the
positioning area.
Hint:
The icon is only active when the s tacker/smoother
is switched off.
Info line:
Return to insertion position
Carriage return to stand-by position
measured from the rear reference switch
Entry: 001 - 515 [mm]
No carriage return
4
29
To Next Page
Loading...
