DURKOPP ADLER DAC BASIC - V 12-2010

Setting the basic functions
49
© 2010 Dürkopp Adler AG
parameter t 03 53
.
CAUTION
A holding force that is set too high may lead to damage to the magnets and the
control unit. Make absolutely sure that the magnets have a reliable power on period
(ED) and set a suitable duty cycle for it in accordance with the table below.
Value
Duty cycle
Effect
5
100
5%
100%
low holding force
high holding force (full activation)
When pushing the pedal forward, with a raised sewing foot the start up delay, which can be set with parameter t
03 10, comes into force.