DURKOPP ADLER DAC BASIC - V 12-2010 User Manual

© 2010 Dürkopp Adler AG
Setting the basic functions
DAC basic/classic
50
12.6 Turning Back
L
C
P
Min
Max
Unit
Description
t
12
00
0
1
-
Turning Back
0 =
No;
1 =
Yes
t
12
01
0
180
°
Moving angle of rotation
t
12
02
50
255
ms
Waiting time up to the turning back
The turning back function runs after the cutting procedure. When the stop position is reached the drive stops for
the
duration of the reverse rotation power on delay ( parameter t 12 02). Then it turns back at positioning speed at
the angle set
by parameter t 12 01.
12.7 Assigning the function keys (smart keys)
The keys are called smart keys which means that the different functionalities can be applied directly to these
keys.
These are programmed using the P key on the OP1000 followed by pressing the corresponding key for about 2
seconds. Confirm the selection by pressing OK.
12.7.1
Assigning key F on the OP1000
The
key is called a smart key which means that various functionalities can be applied directly to this key.
This is programmed using the P key followed by pressing the F key for about 2 seconds. Confirm the selection by
pressing OK.
L
C
P
Min
Max
Unit
Description
t
52
20
0
13
-
Setting the input function for the OP1000 "F" key
0 =
no function;
1 =
on threading help;
2 =
Bartack suppression/recall;
3 =
Manual bartack;
4 =
Half stitch;
5 =
Full stitch;
6 =
Direction finder position;
7 =
Turning back
8 =
Input function module 1;
9 =
Input function module 2;
10 =
Input function module 3;
11 =
Switch high lift for walking foot;
12 =
Ornamental Backtack;

DURKOPP ADLER DAC BASIC - V 12-2010 Specifications

General

Brand	DURKOPP ADLER
Model	DAC BASIC - V 12-2010
Category	Sewing Machine
Language	English