DURKOPP ADLER DAC BASIC - V 12-2010 User Manual

Setting the basic functions
57
© 2010 Dürkopp Adler AG
12.11.2 Setting other positions
The lower or upper position of the needle can be set directly using parameter t 08 12 or t 08 13 or by using
parameter t 08 11 in the same way as already described in 4.4.1.
The angle settings always relate to the set reference position.
12.12 Holding force when idle
L
C
P
Min
Max
Unit
Description
t
08
6
0
2
-
Motor brake when stopped normally
0 =
no brake;
1 =
Brake for duration of d0815;
2 =
Brake when stopped permanently active
t
08
7
0,1
6,00
A
Holding current when machine idle
t
08
8
0
255
-
Responsiveness to changes in the position
t
08
9
0
999
ms
Motor brake time period
This function prevents unwanted wandering of the needle when the machine has stopped.
The effect can be checked by turning the hand wheel.
•
Holding force takes effect when idle
- for a stop in the seam
- after the end of the seam
•
The effect can be set
•
The higher the value set the stronger the holding force
12.13 Setting parameters for backtack and seams
12.13.1
Stitching programming
L
C
P
Min
Max
Unit
Description
t
07
00
0
2
-
Treatment position-2 in seam ways.
0 =
Demolition of the seam. The next seam way is sewn; The seam is
broken off with thread trimmer at the last seam of the program.
1 =
Demolition of the seam with thread performances (even if inactive).
The next seam process is a free seam.
2 =
Demolition of the seam with thread performances (even if inactive).
Seam program is stopped.
t
07
01
0
1
-
Automatic system business.
0 =
off;
1 =
on

DURKOPP ADLER DAC BASIC - V 12-2010 Specifications

General

Brand	DURKOPP ADLER
Model	DAC BASIC - V 12-2010
Category	Sewing Machine
Language	English