DURKOPP ADLER DAC BASIC - V 12-2010

© 2010 Dürkopp Adler AG
Setting the basic functions
DAC basic/classic
60
12.13.2.4 Stuffing program
L
C
P
Min
Max
Unit
Description
t
00
23
0
1
-
Start backtack as a stuffing program.
0 =
Off;
1 =
On
Difference between this and standard backtack:
The number of stitches for the first forward run can be set with buttons C+ and C-.
The thread is cut after the stuffing program finishes if the thread trimmer is active.
If the number of segments set by button D is 0, the stuffing program runs until pedal setting -2 ends the program.
12.13.2.5 Synchronising backtack by adjusting speed
L
C
P
Min
Max
Unit
Description
t
00
35
0
1
-
Reducing speed when shifting the feed dog
0 =
Off;
1 =
On
t
00
36
0
2000
rpm
Wished speed reduction when shifting the feed dog.
If parameter t 00 35 has been selected, one stitch before the backtack magnet is turned on and off, the
backtack speed is switched to the backtack synchronization speed. After the backtack magnet have been turned
on and off
at the next "Needle up" position the backtack speed is released again. If the synchronization speed, which can be
set with
parameter t 00 36, is higher than the backtack speed, the backtack speed is used.