DURKOPP ADLER DAC BASIC - V 12-2010 - 5.4 Programming Stitching Programme III

© 2010 Dürkopp Adler AG
Programming at user level
DAC basic/classic
20
5.4 Programming stitching programme III
With stitching programme III up to 15 freely programmable stitching programmes can be programmed with a
maximum of 25 partial runs and a maximum of 255 stitches.
Programmable functionalities differ in two areas, global functions related to the stitching programme and local
functions related to the partial run.
Global functions:
•
Soft start
Local functions:
•
Interlocking
•
Reverse sewing (NA, NE)
•
Thread clamp (FK)
•
Thread cutter (FA)
•
automatic elevation of sewing foot after thread cut
•
Needle position when sewing stops
•
automatic elevation of sewing foot when sewing stops
•
Reduced speed
•
Partial run without stitch counting
You can browse forwards and backwards through the partial run parameters with the
button and the
button.
Programmed seam runs where the number of stitches = 0 will not be included when running the programme.
Programmed seam runs where the number of stitches is < 0 will be run as a partial run without stitch counting
when running the programme. (When the number of stitches = 0, by pressing button D- you get to the mode for a
partial run without stitch counting (NC))
Changed parameters or functions are applied to the stitching programme immediately, i.e. the changes are
effective immediately.
Example:
Butto
n
Position
Setting
Settings
Display
17
Programming
partial runs S1 - S4
19