E15h SPRAYER- Pressure Alarm
4.5.4 SET THE PRESSURE 1 HIGH ALARM POINT
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2, the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press LINE 1, until the focus is on PRESSURE ALARMS
• Press ENTER to select PRESSURE ALARMS
Note:
If alarm is OFF, to switch the alarm ON. See Section 4.5.3
• Press LINE 2, until focus is on ALARM POINT
• Press ENTER to edit the value.
An asterisk (*) will be displayed
• Press INC/DEC buttons, to set the alarm point in 10kPa increments
• Press ENTER to accept the changes
55
V 1.0 11/05
To Next Page
Loading...