Eagle KEE E15 - Change the Job Number; Spray Without Using Programmed Rate

E15h SPRAYER- Operations: Data Logger
7.3.5 CHANGE THE JOB NUMBER
• Connect the programmed module to the data logger interface
• Set the sub area on the console to the sub area shown on the job sheet that
relates to the required job number as previously described
7.3.6
SPRAY WITHOUT USING PREPROGRAMMED RATES
• Connect a module to the interface as previously described
• If the module has been pre-programmed with set rates, spraying in SUB AREA
NUMBER 10 will log only, it will not load in any pre-programmed set rates.
• If the module has no pre-programmed set rates, any of the 10 sub area numbers can
be used for logging purposes.
V 1.0 11/05
76