E15h SPRAYER- Alarm Messages
PUMP SPEED LOW
- This alarm will be displayed when the sensor installed on the
shaft of the pump, and the rpm of the shaft falls below the alarm point.
See section 4.2.2 to set PUMP SPEED LOW alarm point.
To rectify problem increase the pump speed up to operating speed for the pump.
PUMP SPEED HIGH-
This alarm will be displayed when a sensor is installed on the
shaft of the pump and the rpm of the shaft is greater than the alarm point.
See section 4.2.4 to set PUMP SPEED HIGH alarm point.
To rectify problem decrease the pump speed to the operating speed for the
pump.
AUXILIARY SHAFT SPEED LOW-
This alarm will be displayed when a sensor is
installed on the shaft of the pump and the rpm of the shaft is less than the alarm
point.
See section 4.2.6 to set AUX SHAFT SPEED alarm point.
To rectify problem increase the pump speed to the operating speed for the
pump.
AUXILIARY SHAFT SPEED HIGH-
This alarm will be displayed when a sensor is
installed on a shaft of and the rpm of the shaft is greater than the alarm point.
See section 4.2.8 to set AUX SHAFT SPEED alarm point.
To rectify problem decrease the pump speed to the operating speed for the
pump.
SPEED LOW ALARM-
When the SPEED LOW ALARM is displayed, the operator is
driving below the SPEED LOW ALARM POINT. See section 4.3.2 to set alarm
point.
To rectify the problem drive faster.
SPEED HIGH ALARM-
When the SPEED HIGH ALARM is displayed, the operator is
driving ABOVE the SPEED HIGH ALARM POINT. See section 4.3.4 to set alarm
point.
To rectify the problem drive slower.
TANK VOLUME LOW-
This alarm is displayed when the tank volume falls below
the alarm point This is calculated by the operator filling the tank up to a known
volume and the console counting down the VOLUME LEFT which is displayed on
the Working Screen, when the VOLUME LEFT falls below the alarm point set, the
TANK VOLUME LOW alarm is displayed.
See section 4.4.2
AUXILIARY ACTIVE-
will be displayed in the Alarm Window while the AUXILIARY
is switched ON
FLUSH ACTIVE
-Is displayed in the alarm window when the FLUSH function is
active and the boomspray is being flushed out.
96
V 1.0 11/05
To Next Page
Loading...