Eaton DS7 - Page 199

8 SmartWire-DT
8.9 Programming
DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com 195
PNU 927.0 (Parameter level)
Figure 132: PNU 927.0
a Potentiometer
b Parameter soft starters DS7-SWD
c acyclic data
PNU 928.0 (process data level)
Figure 133: PNU 928.0
a Bit 10: Ctl_PLC (only applicable for 7, 8, 9, 11 profiles)
b 1-0-A switch
c DS7-SWD soft starter process data
d Control signal terminals
If parameter PNU 928 is set to 0 (WE1), it will be possible to control the
device using the terminals (the device will then behave like a DS7 soft starter
without a SmartWire-DT connection). It will continue to be possible to read
data via SmartWire-DT.
￫
If the DS7-SWD soft starter is run using the control signal
terminals, the SmartWire-DT system’s ground must be at the
same zero potential.
③
②
PNU 927.0
①
SWD PNUs
0
1
2
SWD
②
①
1
0
0
A
1
④
1
0
A1
(EN)
DS7-SWD Off
DS7-SWD On
PNU 928.0
③