Eaton DS7 - Page 230

9 Appendix
9.5 accessories
226 DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
• Cover
Protection against accidental contact for size 4 DS7 soft starters when connecting cable lugs,
busbars, or using tunnel terminals. When using insulated conductor material to IP1X.
Note: DE6-MNT-NZM mounting kit required!
NZM2-XKSA (260038) for use with:
DS7-34…SX135…
DS7-34…SX160…
DS7-34…SX200…
• Mounting kit
When using terminal covers NZM2-XKSFA and NZM2-XKSA for size 4 DS7 soft starters
DE6-MNT-NZM (107323) for use with:
DS7-34xSX135N0-x
DS7-34xSX160N0-x
DS7-34xSX200N0-x
For soft starter DS7 in size 3: NZM1(-4)-XKSFA
• IP2X protection against finger contact for box terminal
For size 4 DS7 soft starters for box terminals; used to increase the protection against contact to
IP2X. Protection when reaching into the cable connection area with the connection of cables in the
box terminal. If there are two conductors, the maximum cross-sectional area is 25 mm
2
/ AWG 4.
Cannot be combined with NZM-XSTK control circuit terminal.
NZM2-XIPK (266773) for use with:
DS7-34…SX135…
DS7-34…SX160…
DS7-34…SX200…
• IP2X protection against finger contact for cover
For size 2 DS7 soft starters and NZM2-XKSA cover
NZM2-XIPA (266777) for use with:
DS7-34…SX135…
DS7-34…SX160…
DS7-34…SX200…
More information on SmartWire-DT can be found in the Eaton online catalog at:
http://www.eaton.de/EN/EatonDE/ProdukteundLoesungen/Electrical/Kundensupport/index.htm
￫ Customer support ￫ Catalogues ￫ Online Catalogue