Need help?Do you have a question about the Eaton PROFIBUS-DP EZ204-DP and is the answer not in the manual?
Prerequisites and precautions before starting device installation.
Identifies the intended audience for this user manual.
Lists related operating manuals for other device series.
Defines abbreviations used throughout the manual.
Explains symbols and conventions used for clarity and warnings.
Illustrates the integration of EZ204-DP within a PROFIBUS-DP system.
Details the view and components of the EZ204-DP device.
Describes data transfer capabilities with EZ700/800 and EZD-CP8 devices.
Highlights incorrect applications and limitations of EZ/EZD devices.
Provides instructions on physically attaching the EZ204-DP to the basic unit.
Details the standard connection procedure for the 24 V DC power supply.
Explains how to connect the PROFIBUS-DP interface using a SUB-D plug.
Shows the pin assignment for the PROFIBUS-DP 9-pole SUB-D connector.
Explains the necessity and external switching of bus terminating resistors.
Discusses measures to minimize electromagnetic interference for the communication fieldbus.
Details the required electrical isolation for the EZ204-DP interfaces.
Describes automatic baud rate detection up to 12000 Kbit/s.
Specifies cable types and maximum bus segment lengths according to IEC 61158.
Outlines the steps and expected LED status upon initial device power on.
Explains methods for setting an unambiguous address for PROFIBUS-DP stations.
Details the requirements and process for setting the address using the basic unit's interface.
Describes how to configure the PROFIBUS-DP station address via the EZSoft PC software.
Explains the function of the POW and BUS status LEDs on the EZ204-DP.
Discusses the impact of EZ-LINK communication on the basic unit's cycle time.
Lists available EZ204-DP slave modules selectable via PROFIBUS-DP Configurator.
Describes standard and additional diagnostic data bytes transmitted by the device.
Explains the purpose and availability of the PROFIBUS-DP GSD file for device selection.
Confirms EZ204-DP's certification as a PROFIBUS-DP device.
Details input data bytes for operating mode and status of outputs S1 to S8.
Explains receiving 1 byte of coil output data S1 to S8 via PROFIBUS.
Describes output data bytes for operating mode and setting EZ/EZD inputs R9-R16 and R1-R8.
Explains sending 1 byte of coil output data S1 to S8 via PROFIBUS.
Explains the procedure for extended data exchange using the 9-byte control command module.
Details the process of reading and writing image data, including general notes.
Provides an overview of operands, their meaning, read/write capability, type, and page reference.
Explains extended data exchange for EZ800/EZD using 9-byte control commands.
Describes commands for reading and writing date and time, referencing other manuals.
Details telegram structure for setting Daylight Saving Time (DST) parameters.
General| Brand | Eaton |
|---|---|
| Model | PROFIBUS-DP EZ204-DP |
| Category | Recording Equipment |
| Language | English |
To Next Page
