Eaton RTK 725B range - Page 10

4
INM 725B Rev 21
Tropicalisation
Coating
X
Not required
C
Tropicalised
Ground Detection
1-G
1 = 1 cell wide to 9 = 9 cells wide
A = 10 cells wide to G = 16 cells wide
Additional Remote
Pushbutton Inputs
(3 per card)
X
Not fitted
1-A
1 = 3 x additional remote pushbutton Inputs fitted to
9 = 27 x additional remote pushbutton Inputs fitted
A = 30 x additional remote pushbutton Inputs fitted to
Common Relay
Cards (4 per card)
X
Not fitted
1-7
1 = 4 x additional common relays fitted to
7 = 28 x additional common relays fitted
Time Stamping
X
Not fitted
T
Time stamping on alarms enabled
Synchronisation
Card
X
Not fitted
S
Sync Card fitted for use with a remote GPS or IRIG B Signal
Communication
Hardware
X
Not fitted
E
Entry Level – Addressing each alarm card individually
S
Standard – RS485 and Ethernet (SNTP only)
A
Enhanced – RS485, Ethernet, Additional Ethernet Port
Protocol Options
X
Not fitted
1
RTK AMS (Entry Level), Serial Modbus and AMS(Standard)
2
Serial Modbus RTU (Entry Level)
3
DNP3 Unarmed (Enhanced)
4
IEC61850 Unarmed (Enhanced)
5
IEC61850 (Enhanced)
Special Options
X
Not fitted
1-Z
Reserved for Special Options