EasyManua.ls Logo

Eaton RTK 725B range - WRCE Cell Detail (Watchdog; Relay - Comms Enhanced Cell)

Eaton RTK 725B range
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INM 725B Rev 21
39
2.24 WRCE Cell Detail (Watchdog / Relay - Comm’s Enhanced Cell)
Cell type WRCE is used to provide:-
WR cells are equipped with a four channel relay card which provide
Four Common Relays which can be programmed for use as horn, common alarm or
watchdog relays
Each of the output contacts can be set to N/C or N/O using a 3 way header and 2 way
shorting bar located on the card.
The non alarm coil state of each relays can be programmed to be either EN or DE-EN
Enhanced Comm’s Card that provides:
One Isolated 10/100Mb/s Ethernet port via a standard 8P8C (RJ45) connector.
The Enhanced Comms card contains a BR1225 coin cell (3.0V lithium, 48mAH)
The battery in this comms card can be replaced when it reaches the end of its life. In order to
replace the battery, power down the annunciator, remove the comms card, replace the battery
and refit the comms card. Refer to page 123 for instructions on the disposal of the spent battery.
CB10257POP1 - ENHANCED COMMS CARD WITH IE061850
COMMS CARD VERSION USED IN "WRCE" CELLS
(UPPER SLOT)
CB6641POP1 - WATCHDOG / RELAY
RELAY CARD VERSION USED IN "WRCE" CELLS
(LOWER SLOT)
RELAY OUTPUTS
CR2
CR1
WRCE
CR3
CR4
PORT 3
REAR VIEW
CB10257POP2 - ENHANCED COMMS CARD WITH DNP3

Table of Contents

Related product manuals