Eaton RTK 725B range - ACE Cell Detail (Alarm - Comms Enhanced Cell)

38
INM 725B Rev 21
2.23 ACE Cell Detail (Alarm – Comm’s Enhanced Cell)
Cell type ACE is used to provide:-
• Four digital inputs for use with volt-free or powered contacts.
Enhanced Comms Card that provides:
• One Isolated 10/100Mb/s Ethernet port via a standard 8P8C (RJ45) connector.
• The Enhanced Comms card contains a BR1225 coin cell (3.0V lithium, 48mAH)
The battery in this comms card can be replaced when it reaches the end of its life. In order to
replace the battery, power down the annunciator, remove the comms card, replace the battery
and refit the comms card. Refer to page 123 for instructions on the disposal of the spent battery.
ALARM CARD VERSIONS USED IN "ACE" CELLS
(LOWER SLOT)
CB6611POP1 - 24/125V SIGNAL INPUT VERSION
CB6611POP5 - 24/125V SIGNAL INPUT VERSION
PLUS TIME STAMPING OPTION
CB6611POP2 - 48V SIGNAL INPUT VERSION
CB6611POP6 - 48V SIGNAL INPUT VERSION
PLUS TIME STAMPING OPTION
CB10257POP1 - ENHANCED COMMS CARD WITH IEC61850
COMMS CARD VERSION USED IN "ACE" CELLS
(UPPER SLOT)
CUSTOMERS
VOLT FREE
INPUTS
3
CHANNEL
2
1
ACE
2C
INPUTS
1C
4
4C
3C
PORT 3
REAR VIEW
CB10257POP2 - ENHANCED COMMS CARD WITH DNP3