101
Global Settings
The Global settings worksheet shows the global setting configured on the unit when the
mapping has been exported.
The spreadsheet has 4 additional sheets. Only the sheet related to the port setting requires to
be completed.
Master Reg – If the port is set for Master and data source is registers.
Master Coil – If the port is set for Master and data source is coil.
Slave Reg – If the port is set for Slave and data source is registers.
Slave Coil – If the port is set for Slave and data source is coil.
NOTE
Slave protocol only requires the output columns to be completed, the source is for
customers reference only.
Setting up master data blocks (Master protocol only)
To Next Page
Loading...
