Various
Settings
ESN security operating procedure
About ESN
This main unit is equipped with
ESN
(ECLIPSE
Security Network). A music
CD
(Key CD) which
has been registered
in
the main unit, is
necessary for ESN. Without
it,
none of the
functions will operate, even when the battery
is
reconnected after it has been disconnected for
maintenance, or the ignition switch
is
turned to
ACC or
ON
after it has been turned to
OFF.
ESN
can
be
set or cancelled using any of the following
methods:
• Key
CD
security
You
can register a music
CD
in
the main unit as
the "Key CD" to
be
used to set or cancel the
security settings.
How to operate the ESN (Key CD)
security
How
to
program the Key CD
II
Check that the power
of
the main
unit is
in
standby.
While pressing button [6], press
the [SCREENITEXT] button, and
hold both for more than one
second.
The "SEC" message appears
on
the
display and changes
to
the "DISC"
message after two seconds.
rnATTENTION
• If a CD has already been inserted, a "SEC"
message appears, and then the front panel
opens and the CD is ejected.
• If a security
is
activated, programming the
Key CD is not available.
60
II
Press the
[.
(OPEN/EJECT)]
iii
button.
The front panel opens.
aInsertthe Key CD
into
the
disc
slot.
A "SEC" message appears, then the
Key
CD
is
ejected. The front panel will
close automatically.
rnATTENTION
• If there is a problem with the inserted CD,
an "ERR" message will appear for two
seconds and the CD will
be
ejected.
Reinsert the ejected CD.
• If the "ERR" message appears on the
display twice
in
a row, the "CHANGE"
message will
be
displayed for two seconds.
In
this case, try another CD.
• Copy Protected
CD
and MP3/WMA CD-
ROM cannot be programmed for Key
CD
security.
• The Security indicator will flash whenever
the vehicle's ignition is switched off.
How to cancel the Key CD
II
Check that the power of the main
unit
is
in standby.
I
While pressing button [6], press
the [SCREENITEXT] button, and
hold both for more than one
second.
The "SEC" message appears
on
the
display
and
changes to the "DISC"
message after two seconds.
II
Press the
[.
(OPEN/EJECT)]
iii
button.
The front panel opens.
To Next Page
Loading...
