Operation
Changing the reception
sensitivity
for
automatic
scanning
The main unit lets
you
select the reception
sensitivity to be used for automatic scanning
of
stations. The two sensitivity modes available for
this main unit are AUTO mode and
OX
mode.
During automatic scanning, the
reception sensitivity switches
automatically to one of two levels.
Initially the reception sensitivity
is
AUTO
set to the low level so that only
Mode
stations with strong signals are
received. If no stations could
be
received, the reception sensitivity
is increased
so
that stations with
weaker signals can also
be
received.
Because the reception sensitivity
for automatic scanning
is
set to the
high level from the start, even
OX
Mode stations with weaker signals can
be
received. (Signal crossover
may result
in
some stations being
hard to hear.)
bt:l
ATTENTION
When
an
optional
HD
Radio tuner unit
is
connected, reception sensitivity is set to the
AUTO Mode. The
OX
Mode is unavailable.
(U.S.A. only)
I
Check
that
the main
unit
is
in
standby.
I
Press and hold
button
[1] and
the
~/MENU]
button
simultaneously
for
more than three seconds.
The mode switches between AUTO
mode and
OX
mode each time the
buttons are pressed.
44
Changing the radio band location
The location for the radio bands used between
the North American region and the Asia/
Australia/Latin region can
be
switched. The
default setting
is
USA (North America).
bt:l
ATTENTION
When
an
optional HD Radio tuner unit
is
connected, radio band location
is
set to
USA.
Other radio band locations are unavailable.
(U.S.A. only)
I
Check
that
the main
unit
is
in
standby.
I
Press and
hold
button
[3] and the
[~/MENU]
button
simultaneously
for
more than three seconds.
The radio
band
switches
in
the
order
shown below each time the buttons
are pressed.
USA
~
ASIA
~
AUS
~
LATIN
~
USA···
When
the
power
is
turned
on,
stations
will
be
searched for automatically,
and
stored
in
buttons
[1]
to
[6].
To Next Page
Loading...
