Various Settings
I
While pressing button [6], press
the [SCREENITEXT] button, and
hold both
for
five seconds.
"SEC" will
be
displayed for two
seconds. Then the six digit rolling code
will
be
displayed.
IIPress the [SCREENfTEXT] button.
"DISC" flashes
on
the display.
You
will have five more attempts
to
insert correct disc.
E!lnsert
the Key
CD
into the
disc
slot.
"OK" will
be
displayed for two seconds
and then the
CD
will
be
ejected.
bId
ATTENTION
• If an incorrect CD is inserted, an
"ERR_
"
("ERR" and error number) message will
appear for two seconds, after which the CD
will be ejected.
• This process cancels the protection for ESN
main unit.
NOTE
If after 5 tries the correct Key CD is not
inserted, the display reads "CALL".
Contact Eclipse for assistance.
It is easy to forget the name
of
your
Key CD. Make a note
of
the album
name to remind yourself (refer to page
110).
62
How
to
turn
the
security
indicator
on/off
Once ESN security
is
activated, the indicator
flashes whenever the vehicle's ignition switch
is
turned off, warning potential thieves that the main
unit
is
protected. However, if do not want this
visible deterrent, it may
be
turned off.
a
With the main
unit
in standby, and
while pressing
button
[2], press
the [SCREEN] button, and
hold
both
for
more than one second.
I
The "IND. FLASH" message
or
the
"IND.-----" message appears on the
display.
"IND. FLASH" means the security
indicator will flash when the vehicle's
ignition switch
is
off,
and
"IND.-----"
means it will
not.
Repeat the above
steps
to
reactivate the flash mode.
How
to
read the Electronic Serial
Number
II
Check
that
the power
of
the main
unit
is in standby.
I
While pressing button [4], press
the [SCREENITEXT] button, and
hold
both
for
more than one
second.
After the "ESN" message appears
on
the display,
an
8 digit number will
appear. This number
is
the Electronic
Serial Number (ESN) of the device.
You
may use this number
to
identify
your Eclipse CD3200
in
the event of
theft recovery.
To Next Page
Loading...
