mATTENTION
If a CD has already been inserted, a "SEC"
message appears, and then the front panel
opens and the CD is ejected.
II
Insert
the
Key
CD
into
the
disc
slot.
"CANCEL" will be displayed and the
CD will be ejected. ESN is now
deactivated.
bId
ATTENTION
If a CD other than the Key CD
is
inserted, the
registration cannot be cancelled.
In
this case,
the "ERR" message is displayed for two
seconds, and the CD playback mode
is
activated.
II
Press
the
[
~
(OPEN/EJECT)]
button.
The front panel closes.
How
to
change
the
Key
CD
II
First,
cancel
the
existing
Key
CD.
Refer to "How to cancel the Key CD".
aNext,
program
a
new
Key
CD.
Refer to "How to program the Key
CD".
How
to
resume
normal
operation
(ESN
security
lock
out)
If power is disconnected while ESN security
is
active (a Key CD was programmed),
operation is disabled until power
is
restored
and the main unit unlocked. Follow this
procedure to resume normal operation.
ESN
security
operating
procedure
When
the
power
is
turned
on
after
the
battery
power
has
been
disconnected,
the
"SEC"
message
is
displayed
for
two
seconds.
The
message
then
changes
to
the
"DISC"
message. Press
the
[~
(OPEN/EJECT)]
button.
a
Insert
the
Key CD
into
the
disc
slot.
"OK" will
be
displayed for two seconds
and the CD will begin playing.
rnATTENTION
•
If
the incorrect CD is inserted, an
"ERR_
"
("ERR" and error number) message will
appear
for two seconds, after which the CD
will be ejected.
• If the "ERR5" (the 5th time an
error
has
occurred) message appears on the display, •
the
"HELP" message will appear, and the
CD will be ejected. When the "HELP"
message appears, carry out the operations
for ESN security lock
out
by following the
procedure in
"What
happens
if
an incorrect
CD is inserted?" on page
61
.
• You must be use the same CD used for
Key
CD programming; a duplicate CD
may
not
work
properly.
What
happens
if
an
incorrect
CD
is
inserted?
I
After
the
5th
incorrect
attempt,
the
"HELP"
message
will
be
displayed
for
five
seconds.
"HELP" will
be
displayed for 5
seconds. Then the serial number will
be displayed.
I!I
Press
the
[~
(OPEN/EJECT)]
II
button
to
close
the
front
panel.
61
To Next Page
Loading...
