Operation
How to operate the tuner
rnATTENTION
• If stations have been stored
in
the memory,
pressing a button from [1] to [6] will enable
you to select a station. (Refer to "Manually
storing stations into memory" on page 43.)
Listening
to
the
tuner
aSwitch
to
tuner
mode.
For details, refer to "Switching Audio
Modes" on page 18.
Tuning
to
a station
There are both automatic
and
manual methods
(one of each) for storing stations
in
memory. The
main unit can store up to
24
stations
in
memory.
There are 6 stations for
AM
and
18 stations for
FM
(6
each for FM1, FM2 and FM3) (initial
settings).
I
Press the [RTN/BAND]
button
briefly
(for
less than one second)
to
switch
to
the desired
FM
or
AM
band.
Radio bands will switch from
FM
1
~
FM2
~
FM3
~
AM
in
order each time
the button is pressed.
II
Press the [SELECT] (Right/Left)
button
to
tune
to
a station.
Right:
Tunes to higher frequencies.
Left:
Tunes to lower frequencies.
42
Press and hold the [SELECT]
(Right/Left) button. The device
starts
to
search
for
stations
automatically.
Right:
Starts searching toward higher
frequencies.
Left:
Starts searching toward lower
frequencies.
rnATTENTION
At times, it may
be
difficult to maintain
optimum reception because the antenna
attached to your vehicle
is
constantly
in
motion
(relative to the broadcast antenna),
encountering continuous variation
in
the
strength of the radio signals received. Other
factors affecting reception include interference
from natural obstacles, buildings, etc.
When
an
optional
HD
Radio tuner unit is
connected, digital broadcasts have reception
priority. (U.S.A. only)
Operations
during
rotary
mode
For the operation method
in
the Rotary mode,
refer to page
19.
To Next Page
Loading...
