Ecoray HF-525Plus

To Next Page

To Previous Page

107

Technical Publication Document NO: SYSTEM-007-ENG (Ver.1.1)

HF-525Plus Installation, Operation and Service Manual

● And fix the bottom cover.

● Check the collimator components like bolts and plates. (Please see the photo below).

Main Page

Technical Publication1
Document NO: SYSTEM-007-ENG (Rev.1.1)1
Table of Contents2
About this Manual5
Revision History6
Safety Instructions6
Introduction7
Intended Use7
Features7
Contraindications to the Use of X-Rays7
X-Ray Protective Equipment7
Classification of Equipment7
Essential Performance8
Intended Patient Population8
Operator Profile8
Symbols Marked on HF-525Plus8
Safety9
General Safety9
Safety from Explosion or Electric Shock10
Risk of Collision10
Radiation Safety10
Radiation Protection11
Electromagnetic Compatibility11
Disposal11
Service Information12
Service Life12
System Description12
HF 252Plus12
Generator13
Console14
Tube Stand15
Handle16
Collimator17
Wall Bucky Stand19
Ceiling Tube Support (Option)20
Hand Switch21
Label22
Installation of HF-525Plus24
Conditions for Installation24
Equipment Dimensions25
Preparations for Installation31
Unpacking31
Electrical Requirements33
Wiring Connection of Main Devices33
Fuse Capacity of Main Parts34
Pre-Installation Checks35
Installation of Generator37
Installation of Tube Stand72
Installation of Ceiling Tube Support88
Functions of Main Components89
Installation of Table Bucky121
Start Installation124
Installation of Wall Bucky Stand128
System Cable Wiring Check134
Calibration136
Generator Calibration136
Installation of Calibration Software Program141
Specifications141
Preparations for the Calibration143
Program Execution for Calibration144
Program Functions147
Operation Part147
Calibration of Radiography150
Start Calibration155
Sequence of Calibration for Radiographic Mode156
Introduction and Using Method159
Introduction159
How to Use Generator159
Cassette Tray171
X-Ray Exposure176
How to Use Tube Stand Handle Bar177
Starting and Shutting down the System181
Preparing for the X-Ray System Operation181
Normal X-Ray System Operation181
Power off182
EMERGENCY Switch Operation183
Specification185
Operator's Console185
Generator185
X-Ray Tube185
Tube Stand186
High Voltage Cable186
Collimator186
Wall Bucky Stand188
Ceiling Tube Support (Optional)188
Dap(Dose Area Product) Meter (Optional)189
AEC (Automatic Exposure Control) Chamber (Optional)189
Maintenance190
An Overview190
Maintenance Schedule190
Maintenance Engineer Qualifications190
Periodic Maintenance Procedures190
X-Ray System Cleaning191
Checklists and Check Methods191
Main Parts List192
Error Code193
Error Type, Display and Error State193
Troubleshooting193
Introduction194
Repair Tools194
Error Type and Display194
Trouble Shooting197
Handle Bar (XR7-HANDLE Board)220
Normal Functioning220
Troubleshooting for Table Bucky221
Appendix 1 EMC - Manufacturer's Declaration222
Appendix 2 Anatomical Programming Radiographic225

Ecoray HF-525Plus - Page 107

Table of Contents

Related product manuals