Ecoray HF-525Plus - Page 3

3
Technical Publication Document NO: SYSTEM-007-ENG (Ver.1.1)
HF-525Plus Installation, Operation and Service Manual
5. Installation of HF-525Plus ______________________________________________________________ 24
5.1 Conditions for installation ___________________________________________________________ 24
5.2 Equipment Dimensions _____________________________________________________________ 25
5.2.4 Table Bucky (6-Way)______________________________________________________________ 28
5.3 Preparations for installation __________________________________________________________ 31
5.4 Unpacking _______________________________________________________________________ 31
5.5 Electrical requirements _____________________________________________________________ 33
5.6 Wiring Connection of main devices. ___________________________________________________ 33
5.7 Fuse capacity of main parts. ________________________________________________________ 34
5.8 Pre-installation checks______________________________________________________________ 35
5.9 Installation of Generator ____________________________________________________________ 37
5.10 Installation of Tube stand __________________________________________________________ 72
5.11 Installation of Ceiling tube support ___________________________________________________ 88
5.12 Installation of Table Bucky _________________________________________________________ 121
5.13 Installation of Wall Bucky Stand ____________________________________________________ 128
5.14 System Cable Wiring Check _______________________________________________________ 134
6 Calibration _________________________________________________________________________ 136
6.1 Generator Calibration _____________________________________________________________ 136
6.2 Installation of calibration software program _____________________________________________ 141
6.3 Preparations for the calibration ______________________________________________________ 143
6.4 Program execution for calibration ____________________________________________________ 144
6.5 Program functions ________________________________________________________________ 147
6.6 Calibration of radiography __________________________________________________________ 150
6.7 Sequence of calibration for radiographic mode __________________________________________ 156
7. Introduction and Using Method _________________________________________________________ 159
7.1 Introduction _____________________________________________________________________ 159
7.2 How to use Generator _____________________________________________________________ 159
7.3 How to use Tube Stand Handle bar __________________________________________________ 177
8 Starting and Shutting Down the System___________________________________________________ 181
8.1 Preparing for the X-ray System Operation _____________________________________________ 181
8.2 Normal X-ray system operation ______________________________________________________ 181
8.3 EMERGENCY Switch operation _____________________________________________________ 183
9 Specification ________________________________________________________________________ 185
9.1 Operator's Console _______________________________________________________________ 185
9.2 Generator ______________________________________________________________________ 185
9.3 X-ray Tube ______________________________________________________________________ 185
9.4 Tube Stand _____________________________________________________________________ 186
9.5 High Voltage cable ________________________________________________________________ 186