EDAN Acclarix AX7 User Manual

Acclarix AX8/Acclarix AX7 Diagnostic Ultrasound System User Manual Safety
- 6 -
temperatures in excess of 55°C.
 Do not kink or pull on the transducer cable.
 Broken or bent connector pins can cause image artifacts. Do not use a transducer with broken
or bent pins.
Network Security Cautions
 Keep your ultrasound system safe to protect the patient information and data from being
modified, damaged or disclosed caused by unauthorized disassembly.
 Always ensure the privacy of patient information and data displayed/stored in the ultrasound
system or exported to external storage devices.
 The software upgrade can only be performed by EDAN-qualified service professionals with
upgrade files of known provenance. Confirm that the system boots to imaging after an
upgrade.
 Make sure the ultrasound system is used under secure network environment, and all the
approved devices connecting with the ultrasound system are physically secure.
 Anti-virus measures such as USB device virus scanning should be carried out prior to using
the USB flash drive.
 Do not connect an USB device with unknown provenance to the ultrasound system.
 When the ultrasound system is returned for maintenance, disposed of, or removed from the
medical institution for other reasons, ensure all patient data are removed from the ultrasound
system.
Federal Communications Commission (FCC) Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
 This device may not cause harmful interference, and
 This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
2.3 Labeling Symbols
The following labels are used on the system:

EDAN Acclarix AX7 Specifications

General

Brand	EDAN
Model	Acclarix AX7
Category	Diagnostic Equipment
Language	English