SE-1201 Electrocardiograph User Manual Basic Operation Guidance
- 35 -
Name Explanation
A Name
Patient Name: within 60 ASCII characters or the equivalent
number of other characters that can be supported by equivalent
memory used by 60 ASCII characters
B ID
When ID Mode is set to Manual, the patient ID is within 30
ASCII characters.
When ID Mode is set to Auto, the patient ID is 0~1999, 999,
999.
When ID Mode is set to Time, the patient ID can be
automatically generated according to the time when you press
the PRINT/STOP key to print an ECG report. Entering the
patient ID manually is not supported.
C Age
Patient Age
The patient age value and the age unit can be set in the Patient
Information window.
D Gender Patient Gender (Male/Female/Cleared)
E Hint Information 1
Including DEMO, Module Error, Overload, Lead Name (When
the leads are off, the lead names will be shown in black on a
yellow background.) For details, please refer to Chapter 11
“Hint Information”.
F Hint Information 2
Including No Paper, Paper Error, Battery Weak, Sampling,
Analyzing, Recording, Testing, Learning, Transmitting,
Transmit Fail, Detecting, Memory Full, U Disk, SD Card, USB
Printer, Lead Off, USB Scanner. For details, please refer to
Chapter 11 “Hint Information”.
G Work Mode Manual, Auto, Rhythm, R-R Analysis or Off
H Heart Rate Actual Heart Rate
I Current Time
Current examination time. Refer to Section 10.9, “Date & Time
Setup”.
J Battery Symbol Identify the current capacity of the battery
K
Press to open the main screen2.
L Filter
EMG Filter: 25Hz, 35Hz or 45Hz
Lowpass Filter: 75Hz, 100Hz or 150Hz
NOTE: This setup modified on the main screen is only
effective for the current patient.
To Next Page
