Edwards SCU-800

SCU-800 Control Unit for Turbomolecular Pump
MT-49E-101-G
Page 5
1
INTRODUCTION
3. Safety instruction label
This label describes instructions before operating the SCU-800.
Figure 3 - Safety instruction label
4. Connector caution label
This label describes lock of the connector.
The label instructs operators to prevent the connectors from being disconnected while the STP
pump is in operation.
Figure 4 - Connector caution label
5. Voltage rating label
This label describes the rated voltage of the SCU-800. Use voltage specified in this label.
Some pumps can be operated in the input voltage between 100 - 120V inclusive. Confirm the
specific pumps in Section 2, "TECHNICAL DATA".
AC100-120V /200-240V ～
5-a
5-b
Figure 5 - Voltage rating label