SCU-800 Control Unit for Turbomolecular Pump
3.5 Attaching the SCU-800 to a rack
CAUTION
The SCU-800 cannot be supported with only the 4 screws on the front panel. Always support it from
the bottom using a support angle. When installing the SCU-800, DO NOT block the ventilation port of
the SCU-800 by the support angle or other things. It will cause the SCU-800 to overheat.
The dimensions of the SCU-800 front panel conform to EIA standards. Therefore, this panel can be
attached to any type of commercially available rack. Attach the SCU-800 as follows:
Note: For the dimensions of the front panel and positions of the screw holes for the rubber feet, refer
to Figure 10 and Figure 13.
Attach the front panel to the rack using the 4 screws Figure 13 (1).
Support the SCU-800 from the bottom using a support angle Figure 13 (2) or a similar tool.
When attaching the SCU-800 to a movable rack, to protect the SCU-800 during transport,
remove the rubber feet from the bottom and attach the SCU-800 to the rack using the screw
holes for the rubber feet.
Front panel 4 securing screws
Figure 13 - Example of securing the SCU-800
To Next Page
Loading...
