SCU-800 Control Unit for Turbomolecular Pump
3.8 Remote communication
3.8.1 Parallel communication
The SCU-800 is fitted with a remote communication port, "REMOTE X7" (refer to Figure 19) to allow
remote input and output signal control via input and output remote signals. This connector is a D-Sub
type (37-pins, socket) that conforms to MIL-C-24308. The screw for connector is M2.6.
Note: This D-Sub type connector is not supplied. Procure the connector for remote connection at
your company.
Figure 19 - REMOTE X7 connector
3.8.2 Serial communication
The SCU-800 is fitted with a remote communication port, "Connector X3A, X3B, X6" (refer to Figure
20) to allow remote input and output signal control by serial protocol. This connector is a D-Sub type
(9-pins, socket) that conforms to MIL-C-24308. The screw for connector is M2.6.
Note: This D-Sub type connector is not supplied. Procure the connector for remote connection at
your company.
Figure 20 - Connector X3A, X3B, X6 (D-sub 9)
To Next Page
Loading...
