Edwards SCU-800

SCU-800 Control Unit for Turbomolecular Pump
MT-49E-101-G
Page 8
1
INTRODUCTION
1.6.1 Cable sets
The following cable sets (optional accessories) are used with the SCU-800 and STP pump:
 STP connection cable - STP pump to SCU-800.
 TMS cable - STP pump to built-in TMS unit in the SCU-800.
 Power cable - SCU-800 to power supply.
Note: Figure 8 shows a typical TMS system installation. System connections and cables differ
according to the type of pump connected to the SCU-800. Refer to the STP pump Instruction
Manual (A) and (B) for full details of connection cables and system connections.
1
SCU-800 control unit
5
TMS valve cable
2
STP connection cable
6
TMS connection cable
3
TMS sensor cable
7
Power cable
4
TMS heater cable
Figure 8 - Configuration of the STP pump with the TMS
1
2
3
4
5
6
7