SCU-800 Control Unit for Turbomolecular Pump
4.5 Remote operation
To select remote operation, slide the "MANUAL/REMOTE" changeover switch on the SCU-800 front
panel to "ON", refer to Figure 9. The "REMOTE" LED illuminates.
4.5.1 Input signal pins
Use input signal pins according to Table 9 and Figure 29. Remote input signals are set to the parallel
port in the remote setting and function during REMOTE operation only, except pins for inputting the
ROTATION INHIBIT.
Two abbreviations are used in Table 9 and Figure 29:
COM: Common Pin
IN: Input Pin
To Next Page
Loading...
