Chapter 1 Introduction
1-9
E1 Semi-automatic screen printer
System Manual
EKRA / Doku Eisermann 01_EINFUEHRUNG_PDF.FM
30.8.02
Safety regulations
It is imperative that all operating personnel and, where applicable, service
personnel observe these sections.
Organisational measures
All fitted safety devices must be inspected regularly.
Safety devices
The E1 semi-automatic printer is equipped with the following safety
devices:
Emergency-stop switches
Emergency-stop switches interrupt the supply of power to the printer. An
emergency-stop switch is fitted. It is located at the front on the left-hand
side of the printer frame.
Safety switches and locks
The E1 semi-automatic printer uses hardware and software safety switches
to prevent injuries caused by printer components during printing.
• When triggered, the hardware safety switches and software safety
switches stop all moving parts.
• Mechanical locks are locked and released manually.
To Next Page
Loading...
