Chapter 1 Introduction
1-14
E1 Semi-automatic screen printer
System Manual
EKRA / Doku Eisermann 01_EINFUEHRUNG_PDF.FM
30.8.02
Structural modifications to the machine
• No modifications should be made and no additional devices attached to
the machine without the prior consent of the manufacturer.
• All modifications require written confirmation from EKRA Eduard Kraft
GmbH.
• Faulty or damaged device components must be changed immediately.
• Only genuine spare and wearing parts should be used. The design and
construction of components from other manufacturers may not be able
to satisfy the stress and safety requirements of the machine.
Cleaning the machine and disposal
• Used materials must be handled and disposed of correctly. This partic-
ularly applies to lubricants, adhesives and solder pastes.
Solder pastes and adhesives which can no longer be used must be
returned to the manufacturer. Lubricants and residues of pastes and
creams must be disposed of as hazardous waste.
• If pastes or adhesives containing solvents are used, the owner of the
E1 printer must ensure that sufficient ventilation is provided. Further-
more, the concentration of vapours containing solvents must be contin-
ually monitored in order to avoid situations which are detrimental to the
health of personnel.
• Cloths soaked in detergent are flammable! Observe the manufacturer’s
instructions.
• The national guidelines must be observed when disposing of waste
materials.
First aid
• If solder paste, adhesive or cream is swallowed, contact a doctor imme-
diately.
• If materials come into contact with skin, wash the affected area thor-
oughly with soap and water.
• If materials come into contact with eyes, rinse thoroughly with plenty of
water.
To Next Page
Loading...
