46
installation.
REMOVING THE OVEN DOOR
WARNING
Do not attempt to disengage the hinge catches with
the door removed from the oven. The hinge springs
could release causing personal injury. Do not lift
or carry the oven door by the handle door.
catch over the retaining arm on each hinge. Lift the
-
zontal position. Pull the door away from the oven while
continuing to lift.
Figure 13
RE-INSTALLING THE OVEN DOOR
Grasp the oven door on opposite sides and lift it until the
door hinges are aligned with the openings in the oven
the horizontal, slide the hinges into the openings until
the bottom hinge arms drop fully into the two hinge
receptacles. Lower the door to the fully opened posi-
tion, and then rotate the two hinge catches toward the
oven.
Open and close the door completely to ensure that it
is properly installed.
Peel off the protective layer of plastic that covers the
door panel.
INSTALLING THE 36” RANGE OPTIONAL
BACKGUARD
-
guard in place. These instructions cover the installation
Installing the Range Optional Backguard:
WARNING
Be sure the range is not connected to gas or power
before procedding.
3. To avoid scratches, place small scraps of thin
card board on the rear of the side panels where
assistance of at least one other person, carefully
range top. Special attention should be given to
panels.
same location in which they were removed from
To remove
oven door
rotate catch
as shown
To Next Page
Loading...
