Electrolux E30GF74GPS - Removing the Control Panel Trim; Removing the Top Burner Valve

70
71
2. Remove the control panel, control panel trim
and the burner valve switch.
3. Using a 5/8” wrench disconnect the main gas
line to the burner.
4. Using a 10 mm wrench disconnect the simmer
burner gas line from the valve
3. Using a common screwdriver, turn the simmer
 burneroricecounterclockwise.
Removing the control panel trim:
1. Disconnect power and remove the control
panel.
2. Remove the (4) screws, two on each end, and
lift the trim off.
Removing the top burner valve:
1. Disconnect power and turn the gas off to the
range.