Electrolux E30GF74GPS - Releasing the Top Burner OriCe Mounting Plate Assembly; Removing the Top Burner Igniter

92
93
3. Using a 1 1/16” wrench release, the locking nut
 andtheoriceassemblywilldropdown.
Releasing the top burner orice
mounting plate assembly:
1. Disconnect power, and remove the drip pan.
2. Remove the locking nuts on the burner
 oriceassemblies,andthesimmerburner
 oriceassembliesanddroptheassemblies
down.
3. Remove the (2) screws holding the mounting
plate to the front brace.
4. Raise the front of the plate and pull a plate
forward to disengage the two tabs in the back
from the rear brace.
Removing the top burner igniter:
1. Disconnect power, and release the top burner
 oricemountingplateassembly.
2. Disconnect the wire from the igniter.