Electrolux E30GF74GPS - Removing Oven Door Handle; Removing Outer Door Panel Assembly; Removing Door Handle Studs

72
73
2. Remove the (20) screws, four on each side,
 sixonthetopandsixonthebottom,
holding the outer panels to the inner panel and
lift the outer door panel package off.
Removing door handle studs:
1. Remove the outer door panel assembly.
2. Using (2), 10 mm wrenches, one to hold a stud
and one to remove the nut, remove the nut and
lift the stud off.
Removing oven door handle:
1. Using a 3/32” Allen wrench remove the (4) set
screws, two from the bottom of each end of the
handle, and lift the handle off.
Removing outer door panel assembly:
Note: The outer door panel, outer glass
and Electrolux logo are replaced as a
package.
1. Remove the oven door from the range and
place it face down on a soft surface.