Electrolux E30GF74GPS - Removing the Broiler Igniter Mounting Bracket; Removing the Broiler Burner; Removing the Oven Vent Covers

80
81
4. Remove the (2) screws holding the igniter to the
bracket and lift the igniter out.
5. When reinstalling the igniter use a common
screwdriver with a small blade, inserted into the
bottom of the wire terminals, to guide the wires
through the ceramic block and up through
the installation.
Removing the broiler igniter
mounting bracket:
1. Disconnect power from the range, remove
the oven racks and drop igniter down.
2. Remove the (2) screws holding the bracket to
the oven liner and the bracket will drop down.
Removing the broiler burner:
1. Disconnect power from the range, remove
the rear panel, drop the broiler igniter down and
remove the broiler igniter bracket.
2. Disconnectthebroileroriceassemblyfromthe
broiler burner.
3. Remove the (10) screws, three on each side,
two in the front and two in the rear, holding the
broiler brackets in place.
4. Let the front of the broiler burner drop-down and
pull the burner forward and out of the oven.
Removing the oven vent covers:
1. Remove the oven racks.