Electrolux E30GF74GPS - Removing the Oven Door; Removing the Oven Door Seal

72
73
5. Using a 5/16” wrench removes the (2) bolts
clamping the valve to the manifold and lift the
valve off of the manifold.
Note: Before reinstalling or replacing the valve
make sure the rubber seal and locating
cylinder are in place.
Note: When reinstalling the valve, connect the
  exibletubingrst,thensetthevalveonthe
manifold pipe and tighten down the clamp,
then connect the simmer burner gas tube.
Removing the oven door:
1. Rotate the hinge locks to the door so that
when the doors is closed they will take the
spring pressure off the hinges.
2. Close the door until you feel, the hinges
release from the guide pin and then lift out on
the door.
Removing the oven door seal:
1. Open the oven door.
2. The oven door seal is held to the inner liner of
the oven door by spring clips and can be pulled
straight off.