GROUNDING
1 The range is equipped with a three-prong power
standard three-prong grounding wall receptacle
2 Where a standard two-prong wall receptacle is
encountered, it is the responsibility and
obligation of the customer to have it replaced
with a properly grounded three-prong wall
receptacle. Do not cut or remove the grounding
prong from the power cord.
CONNECT RANGE TO GAS SUPPLY
1 Turn off gas.
2
internal thread of regulator inlet.
3
and regulator inlet.
4
valve . Do not allow the valve to move or turn.
5 Position the range into the cabinet to allow
valve.
6
all range controls are in th “OFF” position and turn
on main gas supply valve.
7
exists before use
The appliance must be isolated from the building’s gas
supply piping system by closing it’s individual manual
shut-off valve during any pressure testing of the gas
supply piping system at test pressures equal to or less
CONNECT RANGE TO GAS SUPPLY
WARNING
the gas supply to the range by turning the gas
shut-off valve to the “OFF” position.
own high pressure regulator. This is in addition to
the pressure regulator provided with the range.
regulator must never exceed 1/2 pound per square
inch.
INSTALLING THE RANGE
leveling legs as required to position the top frame at the
desired height, based on the cabinet and countertop
installation. Carefully slide the range into position in
the cutout.
Make sure the anti-tip bracket is installed as
directed
1. Slide range forward.
attached to the wall behind the range.
Installing the burner components
To Next Page
Loading...
