Electrolux E30GF74GPS - Removing the Bake Burner Safety Valve Mounting Bracket; Removing the Bake Burner OriCe Assembly and Mounting Bracket; Removing the Bake Burner OriCe

82
83
3. Remove the screw holding the valve to the
valve mounting bracket and slide the valve out.
Removing the bake burner safety
valve mounting bracket:
1. Disconnect power, turn the gas off to the oven
and remove the kickplate.
2. Remove the bake burner safety valve from its
bracket.
3. Remove the (2) screws holding the bracket to
the front panel and lift the bracket off.
Removing the bake burner orice
assembly and mounting bracket:
1. Disconnect power, turn the gas off to the oven
and remove the kickplate.
2. Usinga5/8”wrenchdisconnecttheexiblegas
 linefromtheoriceassembly.
3. Removethe(2)screwsholdingtheorice 
assembly mounting bracket to the front panel
 andpulltheoriceassemblyout.
Note: When reinstalling the orice assembly
adjust the orice assembly so that the
bake burner is level.
Removing the bake burner orice:
1. Disconnect power, and remove the kickplate.
2. Removetheoriceassemblyandmounting
bracket.