EMC VNX VG2/VG8 Gateway Configuration Setup Guide
10
Warnings and Cautions
EMC CONFIDENTIAL
In case of fire or other emergency involving the EMC product, isolate the product’s
power and alert appropriate personnel.
Trained personnel are advised to exercise great care at all times when working on
EMC hardware.
Remember to:
◆ Remove rings, watches, or other jewelry and neckties before you begin any procedures.
◆ Use caution near any moving part and any part that may start unexpectedly such as fans,
motors, solenoids, etc.
◆ Always use the correct tools for the job.
◆ Always use the correct replacement parts.
◆ Keep all paperwork, including incident reports, up to date, complete, and accurate.
Static precautions EMC incorporates state-of-the-art technology in its designs, including the use of LSI
and VLSI components. These chips are very susceptible to damage caused by static
discharge and need to be handled accordingly.
Before handling printed circuit boards or other parts containing LSI and/or VLSI
components, observe the following precautions:
◆ Store all printed circuit boards in antistatic bags.
◆ Use a ground strap whenever you handle a printed circuit board.
◆ Unless specifically designed for nondisruptive replacement, never plug or unplug
printed circuit boards with the power on. Severe component damage may result.
To Next Page
Loading...