To Next Page

To Previous Page

Install Components in Customer’s Cabinet

EMC CONFIDENTIAL

If the VNX VG2/VG8 gateway was not installed in an EMC cabinet at the factory, you

need to install the components in the customer’s cabinet on site. Some cables must be

connected before installing the Control Stations:

◆ Installing components .................................................................................................. 54

◆ Component layout ........................................................................................................ 55

◆ System cabling............................................................................................................... 56

Install Components

in Customer’s

Cabinet

Questions and Answers:

Need help?

Do you have a question about the EMC VNX VG2 and is the answer not in the manual?

EMC VNX VG2 Specifications

General