EMC VNX VG2 - VNX Boot Array Worksheet

EMC VNX VG2/VG8 Gateway Configuration Setup Guide
276
Setup Worksheets
EMC CONFIDENTIAL
VNX boot array worksheet
You will need the following information to configure the connection to a VNX boot
array. This information is entered during
“Step 2: Install latest File OE on CS 0” on
page 139
.
Note: Skip this worksheet if you are configuring a Symmetrix array as the boot array.
SP A Management Port IP Address_____________________________
SP B Management Port IP Address_____________________________
Gateway ____________________________________________________
If you use Unisphere to configure the array, you need the following information.
Unisphere Administrator User Name __________________________
Unisphere Administrator Password ____________________________
You need the following information from the VNX array before installation.
Chapter 8, “Configure the boot array,” provides instructions to collect this
information.
Operating-Environment Revision______________________________
Is Write Cache enabled on the VNX array?
❑ Yes
❑ No
Are privileged user accounts on the VNX array enabled?
❑ Yes
❑ No