EMC VNX VG2 - Set up Data Mover Worksheet

EMC VNX VG2/VG8 Gateway Configuration Setup Guide
284
Setup Worksheets
EMC CONFIDENTIAL
Set up Data Mover
worksheet
The Set Up Data Mover step configures the Data Movers. This step is repeated for
each Data Mover (DM) in the system. This step does not run if a file system has
already been created on the system.
Note: This appendix uses the terms blade, Data Mover, and server to refer to the same device.
You will need the following information:
Data Mover Role
Data Mover 2 (server_2):
❑ Primary ❑ Standby
Data Mover 3 (server_3):
❑ Primary ❑ Standby
Data Mover 4 (server_4):
❑ Primary ❑ Standby
Data Mover 5 (server_5):
❑ Primary ❑ Standby
Data Mover 6 (server_6):
❑ Primary ❑ Standby
Data Mover 7 (server_7):
❑ Primary ❑ Standby
Data Mover 8 (server_8):
❑ Primary ❑ Standby
Data Mover 9 (server_9):
❑ Primary ❑ Standby
Standby DM
❑ None ❑ server_2 ❑ server_3 ❑ server_4 ❑ server_5 ❑ server_6 ❑ server_7 ❑
server_8
❑ server_9
DM Failover Policy
Data Mover 2 (server_2):
❑ Auto ❑ Retry
Data Mover 3 (server_3):
❑ Auto ❑ Retry
Data Mover 4 (server_4):
❑ Auto ❑ Retry
Data Mover 5 (server_5):
❑ Auto ❑ Retry
Data Mover 6 (server_6):
❑ Auto ❑ Retry
Data Mover 7 (server_7):
❑ Auto ❑ Retry
Data Mover 8 (server_8):
❑ Auto ❑ Retry
Data Mover 9 (server_9):
❑ Auto ❑ Retry
DM NTP Servers
IP addresses of Network Time Protocol servers
_____________________________________
_____________________________________
_____________________________________